Catskill-craftsmen 1448 Bedienungsanleitung PDF herunterladen (Seite 5)

STEP 1

ASSEMBLE SIDE PANELS

A. Each side panel consists of two (2) legs, one (1) top side

brace and one (1) glide support brace. When assembled,

diagonal legs will be the same (i.e. Front Right/Back Left &

Front Left/Back Right). Side panels are identical when

assembled -- the drawer glides will determine left and right

sides.

B. Tap a 3/4” pin in each end of the top side braces. Take

each of the 4 legs and install one (1) bastion post per leg, on

the side of the leg which also has two (2) pin holes for the

glide support sticks. Locate post holes. Tap posts in with

hammer until threads engage wood; turn posts down until

the solid shaft hits the wood (all threads are into wood), then

back post out until the hole in the post is perpendicular to

the long length of the leg (about 1/2 turn).

C. Lay out Front Left leg, one (1) top side brace and back

left leg as in Illustration 1A. Note the two pilot holes for the L

brackets are along the top inside of the top side brace.

D. Take the top side brace and drop a barrel-shaped bronze

bastion nut into the nut access hole as illustrated. Threaded

end of the nut faces out. Insert front left leg post into the

hole in the end of the brace, through the side of the barrel

nut, until the hole in the post can be seen through the

threaded end of the nut. Insert the set screw into the nut

and tighten down. The tip of the set screw will seek the

center of the bastion post as it is tightened, leaving a tight

joint. If the joint is loose, check to make sure the set screw is

not cross-threaded or that the post is out too far (not

threaded into leg deep enough.) See Instructions for

Bastions illustrations on page 3 for clarrification of assembly.

E. Insert two 3/4” pins into each end of the glide support

brace. Insert brace pins into the holes on the inside of the

left front leg as illustrated (4 pilot holes out).

F. Attach Back Left leg in same manner.

G. Repeat for other side panel.

Table top “L” Bracket holes

nut access holes

not used

holes for

shelves

TOP SIDE BRACE

Bastion Post

GLIDE SUPPORT BRACE

Glide Support Steel Pin Holes

Illustration 1A

Illustration 1B

Illustration 1C

1 2 3 4 5 6 7 8 9 10 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Catskill-craftsmen 1448 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Catskill-craftsmen 1448