Catskill-craftsmen 1448 Bedienungsanleitung PDF herunterladen (Seite 11)

Illustration 8C

Drawer Front

D. Insert the

B-Nuts into the nut

access holes on the inside of

the Drawer Sides with the threaded

end facing out. Take the Drawer Front and

carefully insert the Posts into the ends of the

Brace Sides, through the sides of the B-Nut until

seated. Push Nut snugly against the wood in

the nut access hole toward the Drawer Front.

Hole should be slightly off-center toward the

Drawer Front. Insert the Set Screw and tighten

down. The Drawer Sides should be tight against

the Drawer Front.

Illustration 8D

C. Take two (2) Bastion Posts, align the threaded

ends of the Posts with the post holes located near the

ends of the inside Drawer Front. Tighten Posts

down until the solid shaft of the Post hits the wood.

Back Post out until the hole/screwdriver slot in the

end of the Post is parallel and in direct line with the

long edges of the Drawer Front.

E. Attach the Drawer Glides (left and

Right) to the Drawer Sides using two

7/16” #6 Pan Head Screws per glide.

Open end of glide goes toward the back

of the drawer.

DO NOT INSERT DRAWER

INTO CABINET AT THIS TIME.

Illustration 8E

1 2 ... 6 7 8 9 10 11 12 13 14

Keine Kommentare

Catskill-craftsmen 1448 Bedienungsanleitung Seite 11