CRAFTSMEN, INC.Assembly InstructionsModel 1582Model 1582A. These units are Ready-To-Assemble. Catskill uses positive fastening methods such as woodscr
4 Usedin this stepThis edge facesthe front of thecartSTEP 6ILLUSTRATION 69 Usedin this step3/8 Phillips Pan Head #6 ScrewA. Tap/insert 3/4 pin into
STEP 7A. Lay Back Panel flat on a smooth surface with holes up.B. Attach Side Panels with 1 3/4 machine screws (bolts) and hex nuts. After inserting
STEP 9A. Install Door by placing a washer ontothe pin on the bottom of the door, thensliding the pin into the hole in the bottomFront Brace.B. Fit the
STEP 10Invert unit or lay the unit on its backto insert the wheels. USE A FRIENDTO HELP WITH THIS PROCESS.A. Insert and tap caster sockets withhammer
STEP 12A. Assemble top by placing the top and the drop leaf upside down on a smooth flat surface. Installhinges using 5/8 #8 screws. The longer part o
STEP 15A. Tilt the bottom shelf and setdown onto the pins.B. Fit the middle shelf into thecart and rest it on the pins. Edgebanding should face out o
STEP 16A. Slide the Drawer into the front of the cart.B. Tap in the 5/8 wooden plugs into the holes on the legs.C. Illustration 16B shows completed 15
For continued beauty and long life ofyour Catskill Craftsmen cart, werecommend Catskill Craftsmens ButcherBlock Oil.If you would like to purchase But
Parts List Model 1582Left Side Panel (1)P/N LFT/SP/HDL-1582Back Panel (1)P/N BP-1582Glide Support (2)P/N GLDSUP-1582Top Drawer Front (1)P/N DF-1582Top
1 3/4 Phillips Flat Head Bolt (8)1 1/4 Phillips Flat Head #8 Screw (28)1 Truss Head Machine Screw (6)5/8 Phillips Flat Head #8 Screw (20)3/4 Long
STEP 1AIMPORTANT - There is a right and a left side panel. Lay them out as shown below in Illustration 1. Pay close attentionto the glides, that they
2. Next, identify the holes to be used forattaching each glide to the side panel.IMPORTANT as shown below, the fullextention glides are only attached
WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 11. The Bastion fastening system
A. Attach the Drawer Back to the Drawer Sides with four 1 1/4 #8 screws. There are left andright sides. Make sure the slots that run
STEP 3A. Attach rack front to the rack sides using bastions. (See bastion assemblyinstructions below for added information.)B. Insert wine bottle supp
STEP 4A. Tap/insert ONE 1 1/2 pin into each end of the door. DONT OVERDRIVE PINS! Pins should stickup about 1/2 when seated.B. Attach the magnet pl
Kommentare zu diesen Handbüchern