Assembly InstructionsModel 54220Butcher Block Island with Raised Panel DoorsGENERAL:1. You have purchased model 54220. 2. Should you need assistance o
STEP 9Magnet A. Stick magnet to magnet plate on a door.B. With all other doors open, close the door. The magnet should be positioned over the wooden b
STEP 10A. Lay the cart on it’s back. Insert and tap caster sockets with hammer until the teeth grab the wood. DON’T POUND SOCKET FLAT OR CASTER SHAFT
STEP 12A. Angle the Bottom Shelf as necessary to pass it through the opening in the cabinet top until it rests on the pins installed in steps 2, 6 &am
STEP 14 A. Invert Table Top on a smooth at surface and make a large ( X ) mark over each of the 4 pilot holes in the bottom. Make marks about 1/2-1”
For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai
Parts List Model 54220Drawer Bottom (1)P/N DBOT-54220Small Middle Shelf (2)P/N SMS-54220Center Shelf (1)P/N CS-54220Bottom Shelf (1)P/N BS-54220Left C
Hardware for 542201 3/4” Phillips Flat Head Bolt (8) 1 1/4” Phillips Flat Head #8 Screw (20) 7/8” Truss Head Machine Screw (8) 5/8” Pan Head Screw (8)
STEP 1A. Tap/insert ONE 1 1/2” pin into each end of all the doors. DON’T OVERDRIVE PINS! Pins should stick up about 1/2” when seated.B. Attach the mag
STEP 3Assemble Spice RackInsert retainer rods into holesFasten Shelves with1 1/4” Phillips Flat Head #8 Screw (Bronze)Pilot holes in shelves go toward
WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste
STEP 5 A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The countersunk holes (reamed out) in the stick are posit
STEP 6 A. Lay Back Panel at on a smooth surface with holes up.B. Attach Side Panels with 1 3/4” machine screws (bolts) and hex nuts. After inserting
STEP 8Door Assembly1 3/4” BoltsWasherNutSlide top front brace down into position to secure doors. Fasten with 1 3/4” bolts and nuts as shown.Insert a
Kommentare zu diesen Handbüchern