Assembly InstructionsModel 51842Butcher Block Island with Flat DoorsGENERAL:1. You have purchased model 51842. This unit is ready to assemble. Catskil
1 3/4” BoltsWasherNutSTEP 8Door AssemblyA. Make sure washers are placed on the pins at the bottom of the doors, then slide the doors down into t
No pilot holes as softwood. 5/8” Pan Head ScrewsSTEP 9Magnet A. Stick magnet to magnet plate on a door.B. With all other doors open, close the door. T
STEP 10Install CastersInstall Casters: Locking wheels normally go on the front. Tap in wheel sleeves until teeth bite wood. Don’t atten or wheel stem
STEP 11Towel Bar and Spice RackDecide which side to put the spice rack on then put the towel bar on the other side.Attach side handle/towel bar using
STEP 12Insert Bottom ShelfInstall Divider Panel A. Tap eight 1” pins (4 pairs of 2) into back panel.B. Tap one 1” pin into the holes beside the two
1” Pin2” PinMake sure you put the pins in the side panel at the same height as the pins in the Divider Panel 1”PinEdge Banding OutSlide Divider Panels
STEP 13Table Top5/8” #7
5/8” wooden diskSTEP 14A. Slide panels into place on pins with edge banding out.B. Insert Drawer. C. Re-tighten screws and tap wooden 5/8” plugs int
For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai
Parts List Model 51842Drawer Front (1)P/N DF-51842Drawer Back (1)P/N DBK-51842Right Drawer Side (1)P/N DS-51842/RLeft Drawer Side (1)P/N DS-51842/LGli
Table Top (1)P/N TT-51842Side Panel (2)P/N SP-51842 Bottom Shelf (1)P/N BS-51842Back Panel (1)P/N BP-5184231”Parts List Model 51842Drawer Front (1)P/N
Hardware for 518421 3/4” Phillips Flat Head Bolt (8) 1 1/4” Phillips Flat Head #8 Screw (20) 7/8” Truss Head Machine Screw (12) 5/8” Pan Head Screw (6
7/8” Truss Head Screw1/2” #4 Flat Head Screw5/8” #81” Pin3/4” PinThe counter sunk hole goes out so the bumps go toward the wood.1 1/2” PinFlush at bot
1 1/4” #81” Truss Head Screw5/8” #5See next page to learn how the bastion fastening system works.Also see our video on the Bastion Fastening System at
WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste
STEP 5 A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The countersunk holes (reamed out) in the stick are posit
1 3/4” Bolts1” Pin1 3/4” Bolts1” PinNutNut1 3/4” Bolts1” Pin1 3/4” Bolts1” PinNutNutSTEP 6 A. Lay Back Panel at on a smooth surface with holes up.B.
Kommentare zu diesen Handbüchern