Catskill-craftsmen 51533 Bedienungsanleitung PDF herunterladen (Seite 5)

STEP 2

A. Lay back panel at on a smooth surface with holes up.

B. Attach both side panels (glide wheels go toward front

of cart) with 1 3/4” bolts and hex nuts. After inserting bolts

through the holes in the side panels, through the holes in

the long edges of the back panel, place a hex nut on the

tip of your nger, align nut with bolt and tighten.

C. Look ahead to step 5 which shows side panels

attached to back panel. Glide wheels toward the front.

Note: Make sure you position the side panels according

to drawer side left or right.

Not used

if present

STEP 3

STEPS 3-13 WILL BE ACCOMPLISHED WITH THE UNIT

TOP UPSIDE DOWN (INVERTED), BUILDING UPWARD

TOWARD THE BOTTOM/CASTER END! BE CAREFUL AS

PART DESCRIPTIONS ARE BASED ON AN

UPRIGHT, COMPLETED UNIT!

Assemble top by placing the top and the drop

leaf upside down on a smooth at surface.

Install hinges using 5/8 #8 screws. The

longer part of the hinge goes on the

drop leaf with the short part on the

cart top. Fasten the drop leaf

supports using 5/8 #8 screws.

5/8” Phillips Flat Head #8 Screw

20 Used in this step

STEP 4

Make a large X mark over each of the inside

pilot holes in the bottom. Make marks about 1

1/2” long. These marks will help you align the

cabinet with the inside pilot holes in step 5.

This table top is used on two different models.

The holes on the outside, without markings in

the illustration, are not used.

Side Panel Leg

Inside Brace

Countersunk Hole in Leg

( disk goes in this hole to

hide bolt head! )

Nut Access Hole

Hex Nut

1 2 3 4 5 6 7 8 9 10 11

Kommentare zu diesen Handbüchern

Keine Kommentare

Catskill-craftsmen 51533 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Catskill-craftsmen 51533