Catskill-craftsmen 1544 Bedienungsanleitung PDF herunterladen (Seite 5)

STEP 2

Attach Posts to Legs

A. There are 2 Right Legs and 2 Left Legs. Diagonal

legs are the same ( Example: Right Front/Left Back). For

identification purposes look at illustration 2 which shows

the inside view of a pair of legs.

B. Take all 4 legs and lay out in pairs as in

illustration 2. The posts will go inside edge hole #1 (top),

hole #3 down from top, and hole #6 (last). On the front

legs use holes #3 and #6 only. Put a few drops of

vegetable oil into these holes or dip post threads to ease

screwing of

posts into place.

C. Attach two posts to the inside flat face of each leg,

using the top and bottom outside holes as illustrated.

FOR TIPS ON HOW THE BASTION FASTENING SYSTEM

WORKS SEE LAST PAGE!!!

NOTE: The holes in the posts on the inside edges

will be perpendicular to the long edges of the leg when

properly seated, as pictured in illustration 2. The holes in

the posts on the flat surfaces will be parallel with the short

edges of the legs when properly seated

Left Back/Right Front Right Back/Left Front

Illustration 2

Only on Back Legs

(not used on front

leg assembly)

STEP 3

Brace Guide

Bottom Front, Middle Back,

Bottom Back Brace (3)

Middle Side Brace (2)

Middle Front Brace (1)

Glide Support Brace (2)

Top Side Brace (2)

Bottom Side Brace (2)

PIN HOLE

POST HOLE

Not Used

Not Used on Top or Middle Back Braces

Identify and group like braces together.

A. The Middle Front, Bottom Front, Middle

Back and Bottom Back Braces are exactly the same,

except the Middle Front Brace has a magnet block

attached. Brace size 20 1/2” long x 2” wide.

B. The Top Side Braces are 14 3/8” long x

4 5/8” wide. The Middle Side Braces are identical,

are 14 3/8” long x 2“ wide with no holes on the flat

surfaces. The Bottom Side Braces are identical, are

14 3/8” long x 2” wide but have pin holes and nut

access holes on inside flat face. The Glide Support

Braces are 14 3/8” x 1 1/2” wide with 2 pin holes on

each end & 4 holes on bottom inside.

C. Insert/tap 3/4” steel pins into the ends of

ALL braces. If tight, DON’T OVERDRIVE PINS.

About 3/8” of pin will stick out when seated. Since

the diameter of holes/pins vary from time to time,

some pins will be looser than others. This is not a

problem!

Illustration 3

IMPORTANT!

Middle Side Brace must be

assembled with the off-center

holes towards the inside of the

cart, rounded edge on the

outside of cart. If the brace is

assembled with holes towards

the outside of the cart, the

center shelf will not fit.

Toward inside

of cart

Top Back Brace (1)

PIN HOLE

POST HOLE

1 2 3 4 5 6 7 8 9 10 ... 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare

Catskill-craftsmen 1544 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Möbel Catskill-craftsmen 1544