Catskill Craftsmen 54228 Bedienerhandbuch

Assembly InstructionsModel 54228Butcher Block Island with Raised Panel Doors and Drop LeafGENERAL:1. You have purchased model 54228. 2. Should you ne

No pilot holes as softwood. 5/8” Pan Head ScrewsSTEP 9Magnet A. Stick magnet to magnet plate on a door.B. With all other doors open, close the door. T

STEP 10A. Lay the cart on it’s back. Insert and tap caster sockets with hammer until the teeth grab the wood. DON’T POUND SOCKET FLAT OR CASTER SHAFT

STEP 12A. Angle the Bottom Shelf as necessary to pass it through the opening in the cabinet top until it rests on the pins installed in steps 2, 6, an

5/8” #8 STEP 14Drop Leaf AssemblyA. Assemble top by placing the top and drop leaf upside down on a smooth at surface. Install hinges using 5/8” #8 sc

STEP 15 A. Place the Cart Top on the cabinet. Open the outside doors. Maneuver the Cart Top so that the ( X ) marks/pilot holes in the bottom of the T

For continued beauty and long life of your Catskill Craftsmen cart, we recommend Catskill Craftsmen’s Butcher Block Oil. Our Butcher Block Oil is avai

Parts List Model 54228Drawer Bottom (1)P/N DBOT-54228Small Middle Shelf (2)P/N SMS-54228Center Shelf (1)P/N CS-54228Bottom Shelf (1)P/N BS-54228Left C

1 3/4” Phillips Flat Head Bolt (8) 1 1/4” Phillips Flat Head #8 Screw (16) 1” Truss Head Machine Screw (4) 5/8” Pan Head Screw (8) 3/4” Long 3/16” DIA

STEP 1A. Tap/insert ONE 1 1/2” pin into each end of all the doors. DON’T OVERDRIVE PINS! Pins should stick up about 1/2” when seated.B. Attach the mag

STEP 3Assemble Spice RackInsert retainer rods into holesFasten Shelves with1 1/4” Phillips Flat Head #8 Screw (Bronze)Pilot holes in shelves go toward

WRONG!Post needs to be screwed deeper.WRONG!Post needs to be backed out.CORRECT!Set screw secures post properly.Step 1 1. The Bastion fastening syste

STEP 5 A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The countersunk holes (reamed out) in the stick are posit

STEP 6 A. Lay Back Panel at on a smooth surface with holes up.B. Attach Side Panels with 1 3/4” machine screws (bolts) and hex nuts. After inserting

1 3/4” BoltsWasherNutSTEP 8Door AssemblySlide top front brace down into position to secure doors. Fasten with 1 3/4” bolts and nuts as shown.